Search results

the flywheel bolts right on the bell housing will with some machine work the centre hole that fits over the rear seal housing is larger on the v2203 some of the bolts line up some are off by half of a hole.

does anybody know if a bell housing and flywheel from a v1502 will fit on a v2203:eek:

i have set the valves several times at spec below & above. rechecked compression this morning 325 cold 350 hot . ran it for a couple hours this morning seems to be idling much better. missing on 1 when reved i am begining to think there is a pump issue

not sure . i only ran my b7500 out of fuel once. ifilled with fuel and it fired right up

iwas very careful assembling engine dont see how rings could of aligned. has no blow by. before i reringed & sleeved it was missing on 1. i checked compression it was 100psi. cyl1 had bad ring ridge valves were in poor condition had cyl head done and sleeves on 1&3 had 2 &4 honed and checked...

fuel is new as is filter.not sure what proper compression for this engine.however my b7500 manual says 325-450psi. have checked cam & injector timing as per my other manual.is it possible the engine needs to be worked hard to break rings in

i have a v1502 4cyl diesel it runs horrible. when idling has blue smoke from cyl1 & intermittenly from 3. i have done every thing imaginable new rings & cyl sleeves rebuilt injectors & pump has 300psi compression across the board . when accelerated smoke comes from all 4 cyls. misses&...