Search results

The BT1000A on my L45 refuses to swing left under power. It will swing right without issue and with power, but it refuses to go left. If I put the right stabilizer down and hold the swing control left, the backhoe will swing left from gravity but there is no hydraulic power. As I slowly move...

On my L39, there are 2 rods. One for each brake. They run vertical from the dash board down to the brake linkage setup. When a brake is applied, this arm comes "up" and pulls on the brake linkage. The service manual says to release the jam nut on the top side of the turnbuckle and adjust...

Oh, so I have to disconnect one side of the rod? This is silly. If it works like a turmbuckle like it looks it would be much easier.

No luck. I have sprayed and tried daily. The odd part is that the jam nuts spun off very easy. Am I missing something? The service manual just said to remove the jam nut (1 per linkage) and turn the turnbuckle. ac

I was performing the 600-hour service on my L39 and ran into a snag. My brake pedals have too much travel so I tried to adjust them. According to the manual, I am supposed to loosen jam nuts on the turnbuckles and then adjust the turn buckles. The jam nuts loosened up very easily. However, I...