Search results

Hello, yesterday while raking hay in a rather bumpy field the gauge cluster stooped working (temp and fuel ), and the digital display also. I'm assuming its a fuse but havent checked yet. The radio and AC still work. I have a Case baler monitor and i powered it up when i noticed the gauges not...

Is the M6-111s basically the M108s with DEF. I have the M108s and love it and was looking to find another one really dont want DEF but it basically looks exactly the same as my 108. Want to replace my M126GX with it

would you have the link to the M126gx, my shuttle shift in foward is intermitant and takes forever to go into gear, thank you

thank you for the response, i'll go from there

not a blown fuse, thanks

No one has any comments on this??

Hello, I have a M108s dual speed tractor and the dual speed button doesnt do anything anymore. When i press the buttom on the shifter the rabbit light goes out and comes back on when pressed again but it doesnt change the gearing at all. Ive checked for loose wires under the seat everything...

M126GX hesitates before going into foward, sometimes it will take up to 20 25 seconds before it moves foward. Dealer told me its a solenoid in the steering colum, if so are they easy to replace, thanks

Whitetiger, thanks for your assistance in the replys

D2Cat I am always thankful for information and not rejecting anything. I got busy and hadn't checked back to my question, so here is an update. I was mistaken on this error code given it was 9302, air in fuel. I had the 9502 before so I guess I just had that stuck in my mind when I posted it...

NO already had that replaced. Looked up the code in the manual and it said what I posted

Working the machine and the error code and warning showed up, with reduced power. Service code was 9502 air in fuel system. book says could be low fuel if not call dealer. Almost full tank on machine. I turned off machine and checked engine compartment, everything looked fine no fuel leaks...

Found the problem. Just poor connection on the positive side. Everything was tight before I checked but I decided to loosen the post and clean anyway. There is the big red wire and two other just slightly white wires that connect to the positive battery post, I scraped the white one with my...

You said you checked the battery? What was the static (no load) voltage across the terminals? If it was less that 12.3 volts the battery is discharged. Batteries must be 1.7 volts to be viable for starting and the only way to check that is with an accurate multimeter. Checked battery with...

Hello all, new to the page. Problem is I have a 2013 M126GX, put a new battery in a month ago with no issuses since but I went to start it the other day and it turned over slightly and then stopped. No dash lights, no outside lights come on either. The battery shows to be good on a tester, the...