Search results

  1. N

    Snowblower sprocket breaking

    Ok guys, it's a woods snowblower. The chain wasn't over tightened. It was properly lined up. The shear bolts are what woods recommends. The sprockets I keep ordering look like a white metal, very soft, all 3 sprockets have broken at the set screws. Almost like they are to thin in that area. Can...
  2. N

    Snowblower sprocket breaking

    So I have a Kubota 72 in rear mount blower on my tractor, last winter the small sprocket broke, they replaced it but yesterday the replacement broke again just like the last one. This is the 3rd broken sprocket. They keep breaking near the set screw. Any thoughts on what could b causing this...
  3. N

    Turning up pressure on l3240

    I'm not sure what it is yet, just trying to see how it's done if I need to.
  4. N

    Fuel additive

    Was wondering if anyone uses a fuel addative to keep the injectors clean on a L3240?
  5. N

    Turning up pressure on l3240

    Was wondering how I turn up bucket loader pressure and where to start looking? Thanks
  6. N

    L3240 pedal sensor

    Thanks for the info, I will check that when I get back home.
  7. N

    L3240 pedal sensor

    Thanks Eserv, I will check them when I get home. Thanks
  8. N

    L3240 pedal sensor

    Ok so there are 2 seat switch's, where is the tilt seat switch located?
  9. N

    L3240 pedal sensor

    Ok so I replaced the pedal sensor and still not working. Dealer said it's a safety switch issue. Anyone had this type of problem with there tractor. Mine is a 08 L3240 hst everything works as it should. But when I hit the pedal to move the tractor it dies. I'm 2 hrs from the dealership so really...
  10. N

    L3240 pedal sensor

    I've already bypassed the seat sensor. I was moving snow with the tractor when it started to act up. Seems to only do it during the winter. It did it once last winter, I removed the pedal sensor took it inside for a few days then put back on it worked fine until a week ago. I'm thinking the...
  11. N

    L3240 pedal sensor

    So my l3240 starts up and runs fine, everything works as it should. But after it's started I press the HST pedal and the tractor dies, but if I rock the pedal it will catch before tractor completely shuts off? I'm thinking it's the pedal sensor that's bad? Anyone had this issue? Thanks for any...