Search results

Now that we dragged it down the road it starts with starter no problem. Haven't needed to bleed it again.... yet. However we still didn't figure out why it don't bleed yet (when run out of fuel) either. As you can read above didn't get any more leads as to what to look into or ways to test...

Easier said then done...sometimes the fuel runs out before you notice.....yeah just do this quick (it'll last that long) then fuel up, or runs out on way to fuel up....duh.... Then since it also needs to be bled (and give us trouble) when the lines before the injector freeze unexpected (like...

I understand the difficulties of trying to solve problems with out being there. And I'm having a hard time explaining whats happening here (why I said I'm sounding like an idiot). Yes, the trouble is bleeding and getting it to start after running out of fuel (or freezing lines, or changing...

ok so my brother got tired of it being in the shop. We hooked a chain pulled it out and down the road. Fired right off. Now it will start and run just fine till it needs to be bled again (the thing that is really bothering us). I'd hate to have to drag it each time it runs out of fuel. So I...

That's the up top I'm talking about yes....up top of the head by the injectors. even pulled the lines completely off the injectors a time or two and got nothing. If we did get something it was only really small bubbles. If we had the lines loose and cranked it with the starter steady till the...

I should of said it in the original post. its a manual pull knob kill, and we did have throttle set to wide open and knob pushed in. That it is the injector pump internally has crossed our minds, but refuse to accept it for as well as the tractor run when it runs....its just a pain to bleed to...

When bleeding we get really good pulses of fuel out of the filter bleeders and the bleeders on top of the injector pump. We loosened a couple lines right behind the inj. pump and got fuel to drip out. tightened those back down and still had very little up top. I doubt its linkage (from what we...

Hello just joined up after randomly stumbling upon the page. So we purchased a Kubota M7500DT back in fall. Everyone that dealt with it said it was hard to bleed, we found out the hard way. We ran it out of fuel once and took several hours to get anything for fuel up top to the...