Search results

I used a rosebud tip on a oxy-propane cutting torch, 90% as hot as an oxy-acetylene torch. My limiting factor was the amount of heat conduction onto the axle shaft and not wanting to melt any seals.

This is exactly the kind of idea I was looking for, I am going to try it tonight, thanks!

Yea, one of the lug nut lobes it slightly tweaked from the gear puller last fall. It still lines up with the holes on the rim and I used the tractor like that through snow season. Even if the integrity is gone from that section I think it will be fine with the other studs.

The rear hubs on my b7610 are sized up tight on the narrowest position. The cotter clamp things are also rusted in position. Everyone on the internet seems to have the opposite issue of loose hubs so this is very frustrating. I have reached the point where I am afraid to use my tractor do to...