Search results

Thank You, I will be seeing them tomorrow

Yes the block heater came with the tractor, whether the dealer installed it, I don't know. It was a faulty heater as coolant was leaking into the electrical plug. From the time the service guy determined the problem, to the time they fixed it was 3-4 weeks. One would think in that amount of...

I have a BX2680, bought new in Jan of 18 from a dealer. I Love this little tractor. We have the loader, drive over mower, rototiller, front mount snow blower and pallet forks and we use them all. It was maybe 8-10 months old and I noticed that the coolant level was low. I checked oil, and it...

Hey guys, I just saw this thread.... I have a 2017 bx2680 with loader, snow blower etc. Pretty much since new ive had a weeping issue with that lever lock set up, Well now it has blown.... Ive been in touch with the dealer and they are just giving me the run around..... I took the quick...

Hi All, I have a bx2680. Love this little thing, BUT the loader hydraulic connector, that fancy leaver locking bank of 4 flat face quick connects. Well it has been weeping since new. Tractor not quite 2 years old. Now it has blown one of the seals in the loader up circuit. Dealer tells me...

Now you are coupled to a PTO that will turn up to 2000 rpm. And on the frame is your wood splitter. Or if you prefer a 3 point mounted one the just run a couple hyd hoses back. Or ???

Check out the Vid. Shows the Kubota with the front quick hitch and the snow blower. Now just imaging using the quick hitch and instead of putting the snow blower on, you put on a frame with hyd pump that when attaches, mates up to the coupler, similar to the SB attaches...

Thanks for your input Eserv. I will post when I decide.. happy New Year to ya

Ya the 6.2 gpm would maybe be enough, but then the motor is reved right up. I think I would only need the HP that 1200 - 1500 RPM would make.. saving on fuel and wear on the motor and keeping the noise level down I have the K-Connect front set up, and was thinkin of trying to match up the...

I don't need 15 gpm, just padded it a bit. A good 10 gpm at 2500 psi would require about 15 hp. Im not sure of the hp-rmp curve for the bx2680, but my whole idea is being able to run the tractor at a lower rmp to maintain a good flow to run a wood splitter. At 10 gpm and using a 4" x 18" ram...

Hi All , I have just purchased a new BX2680 with FEL, drive over deck, front mount snow blower and rear tiller. The front end will have the new K-Connect mount for the snow blower and any other Kubota attachment. Im looking at making a hydraulic wood splitter. I Do Not want to run it off the...