Search results

This might be a stupid question but what is the metal rod with a loop on the end that is situated right behind the shuttle shift lever. Far as I can tell it does't do anything. But I'm sure it's there for a reason. Ok, I'm ready to feel foolish now, ha! Thanks, Mark

Hello, I have an M5660 that I want to use a 3pt no till drill(Genesis) with. Beings it is a 3ph drill I would like to have a way to make it float some. On some other forum I saw a slotted top link that would allow it to float some. It was for a Mccormick 250 they said. But I am not able to...

Hey guys, I lost my fuel cap the other day; yep, forgot to put it back on after refueling. Retraced where i went but could not find it. Anyway, I called my local dealer and they want 30 dollars for one. It won't break the bank but, the principal, you know. Anybody have any more reasonable...

Hello folks, I have a M5660 SU . It only has 54 hrs. on it. Last time I used it the 3 pt lever started malfunctioning. It will not stay in the raised position. If I let go of it, it will go right back down and the implement with it. If I hold it up manually the implement will stay up...

I have the M5660 and I'm wanting to change the hyd. filters without replacing the oil. Does anyone know how much I have to drain out so that no more leaks out when removing the filters? I figure I can catch it in a clean tub and put it back in using a filter(Mr. Filter?) of some sort to insure...

I have an M5660 and I was ready to change oil today. I noticed that the oil sump is split because the front drive shaft runs through it. There does appear to be a drain plug on each side which would make sense. But the owners manual makes no mention of a split sump or extra drain plug. Is...

I purchased a new M5660SUHD in May 2017. It now has only 38 hrs. on it. I used it for a couple hrs. the other day for some fel work. I put it away and went home that evening(75 miles away). Later that night it dawned on me that I didn't let the 3ph down when I parked it. It kinda bugged me but I...

Hey guys, just want to run this by you. I'm thinking of ordering a set of Titan pallet forks: 48" , 4000lb. capacity, 6-46" width adjust. I talked to the rep on the phone and he couldn't assure me that they were compatible with my Kubota LA1154 quick detach loader. So I thought I'd run it by...

Hello all, I recently purchased an M5660 and it seems to me the tpl doesn't raise as high as it should. I have a 63 ford 4000 and it seems to raise almost twice as high as the Kubota. I don't know if this is normal for the Kubota or not. I already have the top link attachment in the lowest...

Hey guys, I have an M5660 and I would like to bleed the fuel system. According to the manual you have to loosen the air vent plug on the fuel filter. I'm having trouble locating this. Could anyone tell me exactly where this is? In relation to the water separator, where would it be located?

I recently took posession of a new 5660 with a brush hog attached. It doesn' t seem to lift very high, at least compared to my old '63 Ford4000. I'm not sure if that's all it lifts or is there someway to make it go a little higher by altering the hookup points, etc. I know I could shorten the...