Search results

Thanks for the reply Jeremy. As long as the seat didn’t raise the driving position too high it would be fine. I am just over 6ft tall so reaching the pedals shouldn’t be much of a problem. My only concern it just how high the seat would be. I have a shade hood on my tractor with a fan installed...

Thanks Mike I will look into it. Thanks for the info.

Good evening all. Has anyone with a bx2200 installed a suspension seat on their tractor? If so where did you purchase the seat and what is you opinion of the seat. Thanks in advance for any help that can be provided.

Good evening all. Has anyone actually replaced the stock seat on their BX2200 with a suspension seat? I have the original “rock hard” stock seat and it’s starting to really hurt my back after three to four hours mowing over three acres. I have seen posts about seats being too high and other...

I want to thank those of you that responded for your advice. It’s nice to know that there are folks out there willing to help a fellow Kubota owner.

It’s the circuit the stop solenoid is on (red wire with black tracer)however I solved the mystery today. I removed the ignition switch, disassembled it, cleaned the contacts, reassembled the switch and the tractor seemed to run just fine until I made a rather sudden stop. The tractor shut down...

Follow up on this post. Bought a new stop solenoid and installed it this afternoon. Tractor fired right up and ran for an about a minute. I got on the tractor and was going to run it around the property. Just as I pulled out of the storage area it shut down and blew the 20 amp I mentioned in the...

Good evening all. I have a problem with my BX2200 and I hope one of the members of the forum can help. I have been using my tractor all season mowing the lawn and other tasks around the property. I went to crank the tractor to move into my shop to check the mowing deck adjustment and the the...

Thanks Fordtech, that’s exactly what I needed. Thanks so much for the help.

If a member of the forum has a shop manual for a BX2200 I would appreciate some help with some torque specs. I am replacing the rear (flywheel end) crankshaft seal. I need the torque specs for the flywheel bolts and the crankshaft seal retainer bolts. Any help would be greatly appreciated.

First, thanks Wolfman.Your reply put me on the right track. I'm not what was wrong with whoever was putting the ID tape on the lines the day they made mine but....DAMN!!!!!!!! There was different colored tape on the ends of the same line AND the couplers were wrong as well. All three lines were...

Thanks for the info Wolfman. I will try and explain how I have it plumed. The fluid block I mounted on the pump/differential has the line with gray tape or what the installation manual calls power beyond line on the top fitting the line with orange tape or pump port in on the bottom fitting...

Hello, new member of the forum with an issue I hope some of you fine folks can help me with. I purchased and installed a LA211 loader on my 2000 BX2200. The unit installed with no issues and operates as advertised. Now here is the issue. The three point hitch will not go up. I lowered it as...