Search results

I have both a tractor - L3901 HST with loader and backhoe and a track loader SVL65-2. The tractor uses SUDT for its hydraulics, while the CTL uses 46HD. I have one implement that I would like to share between both (grapple) but I am concerned about the intermixing of the fluids. I asked the...

Just purchased an SVL65-2, and was using it this past weekend. The owner's manual states not to use full load / rpm for the first 50 hours. How do you monitor the RPM on these machines? Searched the operator's manual, and did not see how this is accomplished.

My L3901 HST has started dying suddenly on me. Occasionally I get the engine rpms surging, but most of the time it is like I turned it off with the key. When this happens, I hear no clicking from the fuel pump. When it is running properly, and I shut it off via the key, I hear the fuel pump...

After driving my L3901 through the back part of my property yesterday, I started having problems with the hydraulics. The bucket curls fine, but the bucket raise only works if I pull the handle pack part way. It only lowers if I go past the normal lower position to float, and then it lowers...

I have been removing the 3PH in order to attach the BH. Is this necessary, or is there a position where they can remain attached and not be in the way of the BH?

Took about 45 minutes for my son and I to do air, oil, fuel HST and hydraulic filters, empty the moisture separator, and 6 quarts of 15w40 Amsoil, and grease all of the zerks. Other than crushing the heck out of the hydraulic filter (would not come off with traditional filter remover) everything...

I have a 3901 with BH77 backhoe, and the area between the BH seat and controls is really tight. Has anyone done a mod where the tractor seat can rotate 180 degrees so that I can remove the backhoe seat? I understand that this cannot be done with an operator sitting in the seat. Sent from my...

I checked my level today, and I am just above the bottom line on the stick. Where does everyone purchase this oil? I seen reference to Messick's, where I can order from if I cannot find a place in SE GA that carries it. Anyone know how much fluid is required to go from the lower level to the...

I am adding a 3rd function valve to my L3901 with LA525. I have all of the hydraulics hooked up, and have added my handle to the loader control stick. I have a question on the wiring. The kit includes these modular connectors that connect directly to the solenoids. They each have 3 wires. 2...

I live in southeast Georgia, about midway between Brunswick GA and Jacksonville FL. I have 5 acres that are wooded (pines, oaks) and the ground is borderline wetlands, and has many roots. Many times, the tractor operation leaves ruts 8-10 inches deep, and when you dig a hole you typically hit...

After searching this forum and the web in general, I have been unable to find the Kubota part numbers for kits to add a 3rd function valve to the FEL and BH. Eventually I would like to add a grapple implement for the front, and a thumb for the BH. So this leads to 2 questions: 1) Are there...

Greetings everyone - new to the forum and just purchased a L3901 with LA525 loader, and BH77 backhoe. I have been reading on the forum, and have constructed a dolly for the BH to aid in removing and installing the BH -works great. I have a question on the normal operation of the tractor. I...