Search results

I went to this site and all I could was a blank page.

First, if I offended you with my last response that was not my intent. I wanted to get more comments telling me why my thinking was wrong. Also, you have raised more questions for me. It looks like the bushing you refer to as part #37800-43890 is listed in my parts manual as #38630-4348-0 (part...

I have two problems with your installation. The oil seal is longer from the center ridge to one side than the other side (see the picture). If I put the half with the metal sleeve in the top I am putting the long half of the seal into the shorter pocket (top of axle case) and I will be putting...

Top pocket was shallower than the bottom pocket.

I believe i figured it out. I disassembled it this morning and measured the top pocket and the bottom pocket. Sure enough the top pocket was shallower than the top pocket. The seal was installed with the long side up and the short side down. The reason the top of the seal was scuffed and gouged...

OK, I'm starting to realize a few things. The seal is a two piece seal so that the top and bottom can rotate with respect to each other. The two halves are fastened together with a metal ridge on one side that goes into a rubber lip on the other side. When you look at the seal it looks like one...

I agree the spring should go toward the fluid. I installed the seal in the same way the dealer installed the leaking seal. After installing it and seeing the gap was not the same as the right side I got to thinking something isn't right. That's when I decided that the old leaking seal may have...

The oil seal is the only part I removed and installed.

That may be the reason the gap is larger on the left side because one side of the seal is taller than the other side.

If that's the case, both the dealer and I have installed it upside down.

Evidently my post was not accepted so here goes again. I have a bad leak in the front left axle case on my L345DT. I purchased a new Oil Seal and installed it the same as the old seal. I was concerned for two reasons; why did a seal that was recently installed by the Kubota dealer start leaking...