Search results

Little Beast has been running great until today when I went to disengage Pto while tilling. Lever will not move from Low PTO Speed to nutreal. Tractor and PTO are running fine, no noise. Pto will stop when clutch is engaged. Just will not allow pto to shift to N or high PTO speed. Any...

Have a B5100D with leak at right rear axle seal. How hard is this seal to change out? On the Manual diagram it looks like jack up tractor, remove wheel pry out seal, push new seal in. I have seen a few posts on here that say old seal can be removed by using very very fine drill bit and...

I have had the B5100 with Loader for a few months now and love it. Have learned a great deal from this great site! Have owners and shop manuals. Understand use of knob under seat to switch hydraulics from loader to three point. Purchased a 36 inch tiller that works great. I know that tractor...

Have a 1984 b5100 with loader. manual says either udt or 80 weight gear oil Any opinions on best choice. Will not be using in extreme cold. Have very slight leak at axle. Would the heavier oil be ok for hydraulics or bad for pump?

Recently purchased B5100d. Love the little beast. Runs great at 1100 hours. Has an older Kwik Way loader that works great. I have downloaded operating and service manuals from Kubota Books. Now here is the question. Loader return line is plumbed into the hydraulic fluid fill port...