Search results

Problem resolved! New alternator installed and everything is working fine! Thanks again for everyone's help and advice!

GreensvilleJay you are correct. Zero ohms. I've ordered a new alternator. This has been a learning experience for me, and I appreciate the help from everyone! Best Wishes for a Merry Christmas!

May have spoken too quickly. Tested IG wire with power on, and it tested at approx. battery voltage (page 9-S44 of WSM). Everything seems to work fine with alternator disconnected, so assumed no short in IG wire. However, I pulled fuse and got continuity test between IG and frame, which I...

Checked Grounds, checked and cleaned as many connections as I could, removed battery and had it checked and fully charged, reinstalled battery and when I turned on ignition I heard fuse pop. However, for an instant the intellipanel was working! Fuse was for the alternator. I removed the plug...

Thanks for the response! I do have a service manual and wiring diagram, but since wire harness is all enclosed was unsure where to start. Will try to figure out how to remove cab dash, and start there. Unfortunately, I'm not young and flexible, so it could be painful. Appreciate the help!

Tractor was running fine. A few days later, I went to start and Intellipanel did not light up. I continued to turn key and heard fuel solonoid "click", waited and turned to start - engine turned over, but would not start. Checked all fuses, and they tested fine. Can't be a safety switch...

Should I be checking hydraulic/trans fluid level with the engine running or not running? Does it matter what position the hydraulic pistons are in (extended or not)? Thanks...