Search results

I will have to test the stator wires tomorrow, but I did notice that where the original regulator was there is blackened area on the front of the stator that I assumed was just from the regulator burning out. I hope the stator isn't melted.

Hi Dave-eng, I tried the test you suggested also and with 12v going into the brushes and gen running there was .6v at the outlets.

Hi Jim L. with the gen running there is 35v a/c at each 110v outlet. I wrote the wrong resistance value in the above post about the brushes and armature, it reads 57 ohms not 82. I have not checked the stator windings yet but I will and get back to you. On the terminal block there are 8 wires, 4...

Thanks for the response, I checked resistance between neutral and hot and the meter reads 0. The unit does use brushes which look ok, and the slip rings look ok also. I read the resistance at the brush terminals through the brushes and armature windings and got 82 ohms. with the motor running It...

I have a Kubota generator that runs great but has no output. I opened the generator end cap and found some burned area of the voltage regulator. I was able to find an aftermarket part and installed it but still no output. I tried the re-engergizing trick with another battery and the idle picked...