Search results

Does anyone know if the backhoe buckets are compatible between a Kubota 4520B backhoe and a BX25 tractor/backhoe? Thanks.

Does anyone know of a rebuild kit for the control valve on a B1750? Also does anyone agree that if the seals on the piston and cylinder cap have been replaced, and the lift arms still drop when the tractor is off, then it must be the oil leaking back through the check valve on the control valve?

I was just pushing my weight onto the hydraulic lift arms and it took maybe 15-20 secs to drop. I don't see any external leaks. Is there anything particular in the control valve that is usually the culprit?

I have a B1750 that has low power when lifting the hydraulic lift arms when using a post hole auger. The lift arms will lift the post hole auger up enough to drive around and keep the bit off the ground, but when digging, if the bit is only a few inches into the ground, I can not lift it up...

Thanks for the info. Yes I do have a rototiller. I will try your suggestions. What makes the the clutch disk stick to the flywheel? If I am able to free it up, what will keep it from happening again?

I have a Kubota B1750 HST with a belly mower. When I purchased it, I noticed that the rear PTO would turn when the front PTO was turning for the mower. I thought this was not possible, but it didn't hurt it's operation. Now all of a sudden, when I push the clutch, the PTO does not disengage...

I bought the tractor/backhoe used, but I believe that these are original buckets. I have 3 different sized buckets, but each one looks a little unique. So that seems a little strange. I would have to measure the steel thickness, but it is approx 1/2 inch. There are no bushings on the buckets...

I broke 2 buckets on my 4520B backhoe that is attached to a B1750 pulling stumps. One of the buckets tore which I hope to reweld, but the other one, the bracket that is welded to the bucket that the pins go thru broke out. Basically the pin pulled out sideways breaking the holes on both...