Search results

I'm under spec. should I be looking for a charge pump you think? or digging deeper?

case pressure 5psi @ idle charge pressure 50psi @ idle 2200 rpm case press pressure 15psi max charge pressure 75psi full rev (4000) case pressure 18psi and the gauge is pulsing charge pressure 80 psi and its doing the same ideas guys

I ruled out the clutch with a rpm gauge for timing diesels 2200 rpm front wheels lock down the wheels wouldn't turn the shaft to the hydro remained at a constant speed removed the high relief valve there was a 1mm grove in the valve .03deep Im going to order a new valve and seat and retest...

Ruled out the clutch does not seem to be slipping Float posistion ?? The small valve on the right that goes to the Power steering or is there something else

Hard to say what would be the best way to tell? This is what I have found Flat ground it moves along slowly Put a slight grade the movement all most stops Moves better in reverse Two wheel drive it will barely move forward What about the whining noise normal or abnormal?

looking for a little help I have a b7200 its has a lack of power in forward also a power steering type noise form the Hst area in reverse it has some power but not a lot the screens are clean oil has been changed clutch or high pressure valve? Can you remove the high pressure valves with...

It works very well the guy I got it from said that There is a way to attach the snow blower to the backhoe It runs off the pto run pump I have not tried as of yet I'm doing the clutch which was gone! Hopefully in the next few days I will have it back up My boys like digging holes in the yard!

Just wondering if I'm dealing with aftermarket bits attracted To my b6000 I'm new to the orange tractors I bought it as a package it has a loader and backhoe Neat rig well to over built any wisdom Thanks