Search results

The center hole measures 5-1/4" (probably metric) and the center to center lug holes are 6-3/4" across. I would have to assume that is 135MM on the pilot and 170MM on P.C.D.?

Apparently so! I don't see the L210 on there to compare. Is that because my tractor is not 4WD, I assume? Thank you for posting! :)

I have an L210 serial number 21556

Thanks. I will do that tomorrow. I know the ratio doesn't matter but the chart that was posted showed the circle of the lug pattern, pilot hole, lug count and I figured it would answer my question.

Hello! I saw that @eserv had posted a Rim and Tractor Gear Ratio Chart for L Series tractors. It did not include the oldest L series like L210, L245, L260. Would anyone have that information. I am trying to replace the rear discs on an L210 and have found a rear disc for L245, L260, L275, L285...

The rear wheel width is tough to measure but appears to be 7-7-1/2 inches wide depending on the outside measurement or to the bead. They are six lug with measurements of 17 CM across, 13.5 CM center hole, and 8.5 CM from lug to lug. The rims are 24". The front are even harder to measure as...

I used to install chains on skidders and we always let air out of the tires (not too much) before installing. It could make your life a lot easier during install and make a tighter fit when you are done. :D

Hello! I am new here an excited to talk about old orange with you all and hope to find some helpful information. I recently acquired my father's 1972 Kubota L210 that he had bought new. It has sat for many years and is beckoning me to get her up and running again. I immediately noticed the...