Search results

Hi, I know exactly what they are! They are the rear hanger brackets on my GF 1800 mower, the way they are pictured the holes go up to the frame arms to adjust the cutting height and the lower spring-loaded pin goes into a hole in the deck frame. Dan

Hi I have a GF1800E where the battery light stays on, I have 17 volts ac at the dyno leads when disconnected. Think I found the regulator/rectifier when I took the dash panel apart at the steering pedestal apart. would it be a box about 2 1/2 ins. square 3/4 in thick that has what look like...

Let me know when you find a WSM, I picked up an operators manual on EBay a couple years ago when I got bota,

Ok, Thanks a lot , I have two in-line filters, the first one is full of black looking gunk, then the little pump, then the second filter, that has what looks like fine dust particles in it. Thanks again for the help, will get filters and some biocide/treatment before I run it again! Dan

Hi, can a fuel filter stop/collect algae, and what does it look like? I have a GF1800. Thanks, Dan

Hi, Hokie, The book says I have 18 HP @ 3200 RPM's, is that at "wide-open" max throttle? So when I get this tack, put sticker on flywheel, set WOT at 3200 rpm's, should be good to go, correct??? Then my honey can go to her hearts content !!!!!

I recently replaced the broken throttle cable on my GF 1800 mower. How do I adjust the speed of the motor, it runs too fast, it has no tack to check engine speed. I usually go by the sound of the mower, but DW uses her "ear buds/tunes" and runs it wide open, way to fast. How do you use a tack to...

Well after some haggling (sp) got the blower for $450. It was easier to mount than I figured. Thanks wolfman for the help! Now a couple questions, 1 does anyone know/or have a manual to copy or sell, checked e-bay. 2 How hard are these motors to start in winter, I have a D722 FM engine, maybe...

I'm looking at getting a snow blower for my GF 1800. The seller sent some pic's of what he has and from those I can't see how it would mount. Sooo my question is, does anyone have a TG 2742 that mounts on a GF 1800 that can post some pic's of how it mounts, and the brackets. I know these blowers...

Hi! Andrew, I just took the covers off my deck, looking for a place to hold the input shaft to the gearbox. If it way me, I would put a pipe or strap wrench on the u-joint to hold the shaft or put a bar in the yoke on the u-joint being really, really careful with the grease zerk in there, if you...

Hi! I just removed and sharpened the blades on my GF1800, and I have two (2) bevel(sp) washers on each spindle, with the cup facing up towards the blades, as previously said, DO not over torque. Might try new washers! Hope this helps !! Dan I just use a 2x4 to keep the blade from spinning...

Hi, new to this sight. I just got a L4350dt, it was an estate sale, the old gentleman rode the clutch alot? Anyway, when i press the clutch all the way down, everything stops (like normal), when i let up on it about an inch the pto starts, then when its almost all the way up the trator starts to...