Search results

Ok so I got off work at midnight and in the shop by 12:15. The screen is pulled and cleaned. When I pulled the screen out I noticed there is all kinds of crap (sediment and brown chunky crap) all around the hydraulic port inside the casing. (The same crap that had my screen plugged up tight.)...

Yeah I cleaned the tank and fuel system first. When I started there was no fluid in the hydraulic system so I topped it off. Engine oil was where it should be so I started it to see what I was working with. Since then I have changed all the oil in the front end and ball joints. Engine oil change...

And thanks for the picture Lil Foot, but the lever I am talking about is not listed in it.

Nope, not the three point hitch lever. This one is just above the high/low range lever on the transmission. If the picture loads it is just under the black hose.

I recently came into a 1978 B7100D (geared and 4x4) that has been sitting for the last 15 years. It only has 450 hours on it. I had to rebuild the steering box and clean out the cooling system but now the machine runs great. When I first started it the hydraulics ran good. It has a three point...

Well i figured out what it was and figured I would let everyone know in case someone else has the same problems. While replacing the hydraulic filter as suggested, I located a slotted screw right next to the filter. The screw selects between FEL and No FEL. It was about halfway between the...

The bucket will SLOWLY leak down, but we're only talking an inch after 15 minutes of so. There are no visible leaks and this machine is clean enough to eat off of so it would be noticable. Dump controls work fine but thats because you have gravity helping. It lifts slowly and curls slowly.

Hey everyone, does anyone have experience with a Bushhog M246 Loader? I just bought a L3010 with this loader and I feel like im running in slow motion. The loader has will not move until you run it up to 1500 RPM and to lift much of anything heavy you have to run it up to almost 3000 RPM before...