Search results

Unfortunately the tractor is coming up on 3 years old ... so I will probably get Kubota to take a look ... I have so many things to sort out this time of year that if I start working on it will take months .... months I do not have. Painful $$$s. I will make sure the techs take pictures of the...

I removed the brush cutter. Tractor end of the PTO Shaft spins freely. I did adjust the slip clutch in the spring but probably should check it more often. Thanks.

Was using brush cutter with slip clutch. Hit a small tree stump and carried on for about 30 feet and cutter stopped spinning. Check PTO shaft on tractor and it spins freely. No grinding or metal on metal when I spin but I do hear a slight noise from a bearing. Any thoughts about issue before...

Issue ended up being a failed switch. Unfortunately a replacement switch is $500+ CDN. Way too expensive for me so I added a $1 rocker switch to tide me over until I figure out next steps. Any suggestions for a better hack or how to fix myself would be appreciated.

Photo is really helpful.

Thanks. Ok. Will let you know what I find.

Air ride seat no longer does anything. Before I start investigating any suggestions to troubleshoot? My first thought is to check electrical. Tractor has 1400 hrs.

Update - It is coming up on 8 months and 400 hours with plug only and it is still holding. Good advice.

I keep the tractor in an equipment shed that is open on 2 sides but I am not sure that the cold/ice is the cause. I have noticed that it has been progressively getting harder to move for the last month (above freezing temperatures) but really came to a head after moving a big dump of wet snow...

Loader boom/bucket lever is very stiff when raising boom and bucket. Started about 10 hours ago (1100 hrs on tractor) and has been getting progressively worse with movement being slow/hard to engage and will not release without manually moving the lever/joystick. When the boom and/or bucket do...

Looking for help to sort out how to add work lights using existing wiring. In attached photo you will see a set of wires not used. I have gone through the WSM electrical diagram and I cannot figure out how to energize them. Do I need to add a new switch or is it a fuse issue or it some other...

Thanks. I am going to stay the course and replace the ballast.

Right as rain. The c-clip was covered with grease and dirt.

OK. Will take a look and try to pull the clip. Will send a photo of what I see. Thanks - Dave

Looking for your opinion here. I punctured my rear tire on an old fence when cutting brush. Lost most of my liquid ballast but was able to plug and apply a rubber patch. It has been a month and it is holding even after 100 hours of field work. Trying to decide whether I replace the tire...

I am trying to service my slip clutch on my cutter but after removing the retaining bolt I can not remove the PTO shaft. I have a good 1"-2" of play but can not go any further. Not sure if their is a retaining ring or not because the poorly designed plastic cover is in the way. Does anyone...

Update - I contacted LandPride Sales shortly after my post about the delay and they looked into its status and told me it was on its way. Well, it just arrived. Better late than never.

I am in Prescott (south of Ottawa on the 401) so I will think about the 96" one.