Search results

  1. G

    ZG124E zero turn no start?

    Thanks lugbolt for all the help. It ended up being the relay causing the no start. It's still bogging down when the blades are engaged though. I think I've reached the end of my mechanical ability on this one so off to the dealer it goes.
  2. G

    ZG124E zero turn no start?

    Oh I only get a flash of voltage at the starter when it tries to turn maybe half to a whole tooth. Then the voltage drops to tenths. Glen
  3. G

    ZG124E zero turn no start?

    Where is the brake switch located?
  4. G

    ZG124E zero turn no start?

    Ok I have a good battery, even put a charger on start mode to boost it. Still will barely try to turn the fly wheel. I'm getting 13+ volts on the control/switch side of the solenoid (little wires) and 13+ at the + side from the battery. But not on the starter side of the solenoid. Does it...
  5. G

    ZG124E zero turn no start?

    By jumped, I mean sticking a piece of metal across the top terminals to bypass the solenoid. I'll try a known good battery. But this one tested ok with the cheap harbor freight load tester. I'll also try to get a amp and volt reading to the starter.
  6. G

    ZG124E zero turn no start?

    Ok 1st time poster here so bare with me please. My zero turn wouldn't start this spring so I jumped it off. As soon as I pulled the negative jump cable off the mower died. So I let it run and charge with the other mower still attached for about 40 minutes. It would mow on flat ground but...