Search results

This is from Summits website describing the valve in the 3rd function kit. According to the description the T port is rated at 3050 psi. But is stamped differently on the valve apparently. Time will tell I guess on how it holds up. If it doesn’t I will replace with the valve you mentioned with...

D Did you hook up the way it describes in the directions then? If so, everything working ok?

They’re probably banking on you not using the 3 point hitch or rear remotes at the same time as the 3rd function.

This is Land Pride’s instructions on how to install their third function kit, which is identical to the Summit kit. Goes against everything taught about hydraulic valve labeling/plumbing but maybe the valve is a tandem center valve in which case doesn’t really matter which port is in/out? I...

T Thanks for posting, beat me to it. The directions have you routing flow backwards through the valve. As the power beyond from the loader valve should feed the p port in my opinion. Not sure of the reasoning to feed through the t port. I plumbed mine the opposite of way the directions said...

Thanks everyone so far for your help/replies. To make things more understandable I found a picture of the way I have it plumbed in as well as the valve. The directions that came with the valve kit showed basically swapping the hoses on the p and t ports, which I didn’t think was right so I...

Maybe a grapple in the future some day, but more for a post hole digger. The 3 point diggers around here don’t work very good. We rebuild a lot of fence here on the ranch, just wanting to make life a little easier. I didn’t tap the power from a switched power source but did wire a switch in to...

I installed a Summit Hydraulics third function kit on my MX5200 and in the directions from Summit they have you routing the hose from the PB port on the loader valve to the “T” port on the third function valve and routing the “P” port of the third function valve to the PB port on the valve block...