Search results

My M6-101 isn't shifting as smoothly as I believe it should. It has the 24 speed (3 ranges, 8 speeds per range) Intelli-shift transmission. I noticed it seemed to be shifting hard, especially between 4th & 5th and it was about due a fluid and filter change, so I went ahead and changed them...

The fan operates smoothly without vibration. We will check out the mode switch, thanks for the suggestion

We replaced it

Thanks for the reply. Yes, we checked them.

We just replaced the entire AC system on our M9000 due to compressor going bad. She’s blowing cold but just doesn’t have much airflow. We cleaned/changed every duct and filter on the tractor while we had it all apart. This tractor is new to us so i don’t have a frame of reference as to what...

My M6-101 has recently begun to regen every few hours and I'd like to know why. We are in winter and it's been cold and nasty but when we've operated the tractor we make sure RPM's are up to at least 1500 for easier tasks like pulling a fertilizer buggy but between 2200 - 2300 for heavier duty...

Goodness, My mind is duller than normal at this time of day. Thanks for the suggestion, the logical place to start. We will check cylinder seals when i get back to my shop and have another attachment that uses aux hydraulics to see if they bleed off. If the other attachment bleeds off, I’ll...

We use our SVL 95-2 to pull/clear trees with a Danuser Intimidator. It has worked well but we have developed a problem with the aux hydraulics and I could use some insights to where to start troubleshooting. The problem is once we clamp the tree the hydraulic pressure will bleed off. We can...

Thanks ruger1980, I appreciate the input. It helped me.

I have a KX040-4 mini excavator and some of the lower truck rollers are beginning to leak. I looked at the parts schematic and it shows a plug which leads me to believe I can rebuild it. I have a couple questions/requests...1) Can these be rebuilt instead of replaced? and 2) if possible to...

Thanks everyone. I had another ac tech check it out and it was overcharged.

I have a 2016 M6-101 with 300 hrs. I purchased this unit new. The air conditioner will cool with little to no load on the engine. After some time, 30 min - 1 hr, of working the tractor, such as baling hay, the air doesn't cool. It's not blowing hot air, it's just not blowing the cold air it...

Thanks for the input. It is helpful. I will visit with the dealer about it.

Thanks for the input, Tooljunkie. I had similar thoughts but need some outside opinions, such as yours, that don't have an interest at stake. I want to be reasonable but still have reasonable expectations for how the equipment should perform. Your input is helpful.

I welcome your input to help me sort through the issues with my tractor. I would like to know if I'm reasonable or if my concern is valid. Here's the situation: Here's a Youtube link that shows the issue with my tractor: https://www.youtube.com/watch?v=FP8i8MWwWxc Here's my original post...

Thanks for your input, I appreciate the suggestions.

I had found a similar suggestion about the fouled piston rings or a glazed cylinder. They didn't think this was the case due to the compression of each cylinder testing well within specified limits. What would cause a piston to foul or cylinder to glaze? Does Seafoam void any part of the...

Thanks for your reply Wolfman. They have checked the fuel pressure, injectors and fuel. To my knowledge, they didn't check the valves, turbo or intake. They have done, as best I can tell from my non-mechanic point of view, a pretty thorough job at troubleshooting. They just haven't...

Yes, D2Cat, I'm in West Plains, Missouri.

Thanks everyone for your suggestions and ideas. I appreciate it. I will forward these to Kubota reps. Hopefully, these will yield the solution.