Hey all, on my B1550 I dont seem to have the bars that I circled in the picture. Has anyone ever made home made ones?
B1550 w/ 1640a loader. I am missing x2 bars that help support the bucket when removed
- Thread starter Porcello garage
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Yep simple to do, nothing fancy about them.
To get a good length, measure the pin to pin on the top of the loader bucket as that's where they live when they are not on the sides of the bucket holding it up.
To get a good length, measure the pin to pin on the top of the loader bucket as that's where they live when they are not on the sides of the bucket holding it up.
Howdy,howdy and welcome. I believe you have the answer you need but I'd like to make you aware of an extremely important issue with this particular model when equipped with both loader and belly mower. To prevent $$$$ damage while using loader, there must be 2 braces in place, one under right and left feet, running from loader frame to rear axle. Many people remove those braces to make it easier accessing mower deck "big mistake". Members Lil-foot and Torch wrote really good articles here on OTT about rescuing tractors following this damage. I recommend you familiarize yourself as early as possible and look at your machine.
Once again, welcome and hope you stick around to swap ideas.
Once again, welcome and hope you stick around to swap ideas.