why does my QH10 quick hitch tilt to the right during operation? i constantly have to monitor whatever implement i am using to keep it level. frustrating!
quick hitch tilts to the right during operation
- Thread starter setdhuk
- Start date
Blue2Orange
Well-known member
Equipment
BX2380 with LA344S & QH05. SB1051. SG0554. BB1248. RB0560, Vassar dirt bucket
Image? Assuming tilting off axis clockwise relative to the tractor v. just shifting to the right? And when not loaded with an implement sits level relative to the tractor?
Russell King
Well-known member
Lifetime Member
Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
Do you have rear remote hydraulics and a hydraulic tilt cylinder installed? If so the system is leaking and letting the cylinder length vary.
To test set the level you want, the disconnect both hoses from the valve using the quick disconnects (that I assume you have installed). If no drift then you can hook them back and prove that the drift starts again.
There is a double pilot operated valve that can be installed to allow you to adjust the position but then it magically locks it in place until you intentionally move it again.
To test set the level you want, the disconnect both hoses from the valve using the quick disconnects (that I assume you have installed). If no drift then you can hook them back and prove that the drift starts again.
There is a double pilot operated valve that can be installed to allow you to adjust the position but then it magically locks it in place until you intentionally move it again.
Given available information, it would appear that you need to adjust the leveling assembly on the right side upper lift arm to level the lift arms.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
If your running hydraulic tilt and it's moving on it's own then you have an issue with that system.
Does you tilt cylinder have a load check on it?
Does you tilt cylinder have a load check on it?
Pictures and whose cylinders do you have?
Do the following tests, it is best to have a base line to work from.
Do the following tests, it is best to have a base line to work from.