Recent content by Wideopen38

Which hydraulic valve do I have open or close center. Its only a lb2500 Kubota with a lb400 loader on the front.I bought a open center valve put I can't get the rear lift To go up now.

Yes I had to put it in first them I put a 90 degree into it. Do i need? I don't think my other valve had one.

Okay I had one of the lines backwards the in and out the buckets working again but the lift for the bush hog when you put the lever in the up position it does not move but you pulled the joystick to tilt the bucket back the bush hog lift comes up when you push the lift lever down for the bush...

It says it is opt. Power beyond. Remove steel plug to install/convert to power beyond.

Here are two pictures. Old one is on the left side, new one installed right. It has 7 hoses coming of them. The model I was told to get was WLV21GB5C1 it's a 2 spool.

Ok I did everything you said to do but nothing works at all bucket or lifted I looked at it about 10 times I'm lost.

Ok I fixed the bucket problem it was the lines were wrong so thanks for helping with that problem. Now I have another problem the lift in the back will not go up. I have the 4 lines that go to the bucket and three other lines that go to the back one goes all the way to the back behind the seat...

I have a l2500 4x4 with a lb400 loader. I just replaced the hydraulic valve. The problem is the loader arms goes up about 8 inches and stops,it will go down fine those 8 inches.The bucket will not roll up or down,all of it was working fine before new valve. Does anyone know what the pressure...

Thank you for all your help.

Does it matter that I have 2 joysticks and I have a float for the bucket to.

Just called the dealership $1,700 to replace the control valve body assembly yikes! It's a 2 spool any help would be great.

Serial # 16574

I have a Kubota l2500dt with a loader lb400. The valve body has a plate on it with 1625-ar i can fine much on it. The problem is when I let the valve control handle go the valve is so loose it slide down in the the valve body it moves the bucket or arms on it's on. I don't know if I need to...

I just got a Kubota l2500dt with a front end loader. The 3 time using it the pump started to smoke,get very hot and now noisy. The pump I need is about $600. The shank for that pump is short and has spines on it. I have found the same pump for about $250 but it has alittle long shank on it. Has...

I need a set of stabilizer adjustment bars for a L 2500 kubota tractor where's the best place and the cheapest place to get a set thanks.