whitetiger's latest activity
-
whitetiger replied to the thread M5660 help.What scanner do you have? -
whitetiger replied to the thread l3301 wont start with out starter fluid.What is the pressure at the outlet side of the spin-on fuel filter while cranking the engine over, and what is the pressure with the...
-
whitetiger reacted to North Idaho Wolfman's post in the thread Replacing fan belt on the BX23MLB with
Like.
I'll bet you dollars to doughnuts you got a fan belt for a BX23S and not a BX23D. Wrong #, BX23S Fan Belt 16883-97010 Right #, BX23D... -
whitetiger replied to the thread Wow - I Don't Want To Junk My Tractor - HELP!.Yes, this repair requires the tractor to be separated to replace the seal. The propeller shaft can not be removed with the tractor...
-
-
whitetiger replied to the thread RUNS really Rough if you call that running.I did an L3901 a couple of months ago, although it was liquid fertilizer, not gas, over $13,000.00.
-
whitetiger replied to the thread B8200 won't start after new injectors.Oregon Fuel Injection | Diesel Parts & Injection Pumps The Chinese injectors are only good as a paper weight.
-
whitetiger replied to the thread MX5200 Block Heater Install - Extra metal behind the freeze plug?.That is the way the block is made; it makes removing the soft plug a little tricky. You just take a center punch and tap it through the...
-
whitetiger replied to the thread What size are the bolts and nuts.How about the tractor model, tire/wheel size, and front or rear? We can't quite see the wheel from here.
-
whitetiger replied to the thread Valve lash.Too loose opens and closes too soon, changes the valve timing, fuel-to-air ratio, power output, fuel consumption, and eventually results...
-
whitetiger replied to the thread Inspiration for fumble fingers and arthritic hands.I probably could do the job he is doing using only my toes. My wife could and has done much more complicated service repairs by herself.
-
-
whitetiger replied to the thread Valve lash.I have easily done 75 + and 95% of the time at least 2 valves are too loose. Some I have found at .011" to .013" lash on 1000-hour-plus...
-
whitetiger replied to the thread Model LxxxxDT.What is stamped into the transmission case?
-
Which ”uniform” would you wear…? (or would you prefer we remain uninformed..?)
-
whitetiger replied to the thread Model LxxxxDT.Look in the location shown in (3); the model and serial numbers should be stamped into the housing. You probably have an L3130HST-F or...
-
