Recent content by Vair2

This is good advice. I bought my mini used, did some minor repairs, used it for a number of tasks, then sold it for essentially what I'd spent on it. The work done with it only cost me my time and fuel. In addition, I had the convenience of using it whenever I wanted without having to go rent...

Bought a new TMG TFM-060 and put it to work this last weekend. I had some reservations about buying a cheep flail mower, but it held up well despite the multitude of rocks that I found on the unmaintained pasture.

I just sold my Bobcat 323 mini so that I could afford to purchase the MX5200 with BH92 for a larger property. There is no comparison between a tractor backhoe and a dedicated excavator. That said, I chose the larger TLB over the mini because it is a much more general purpose machine that can...

The parts dept got back to me and it's a 25mm pin. I'll just buy a draw bar pin. It's cheaper.

Does anyone have the length and diameter measurements? Mine is missing and I'm wondering if a drawbar pin would work.

Did you ever find your answer? I want to install a ROPS on my B7001.

The loader has been modified/repaired at some point, and the bucket is very slow to tip and does not tip very far. The loader frame appears to have had some sort of extension (ROPS) at some point. I am amazed at how clean this machine is otherwise, with no noticeable wet spots. The key is...