Tx Jim's latest activity
-
TTx Jim replied to the thread M7040 hydraulic shuttle problems,.I tend to think the clutch control, shuttle control or modulation valve is at fault. I'll be monitoring your thread due to my owning a...
-
TTx Jim reacted to kevinj's post in the thread Kubota dealer says engine is shot on RTV500 with
Like.
I would perform some diagnostic tests to be sure what is wrong. I also would never pay that kind of money for the diagnosis you got... -
TTx Jim replied to the thread Post-Clutch Replacement Issues.I agree with Fedup. on clutch mechanism needing some free travel. 1''-1-1/2'' clutch pedal free travel is normal. 3'' free travel of...
-
TYou know it has to have at least SOME free play. If that is minimal already and it still won't fully release with pedal fully down, the...
-
TAnd you haven't been back to the "guy in his garage" yet to get his opinion?
-
TTx Jim replied to the thread Post-Clutch Replacement Issues.How much free travel does clutch control mechanism/pedal have?
-
TI don't think there is anything wrong with the fuel pump. It sounds like the clutch isn't disengaging all the way and that is why you...
-
TTx Jim reacted to GeoHorn's post in the thread 20 hours on new Machine, Hydraulic Pump Failure, Advice needed. with Like.
Seems like a good solution to me. I bought a new Ram 2500 out of state …(my truck was wrecked in KY while on a trip) ….and the transfer...
-
TTx Jim reacted to TheOldHokie's post in the thread 20 hours on new Machine, Hydraulic Pump Failure, Advice needed. with Like.
Not a gear pump and a whole different animal. Dan
-
TTx Jim reacted to TheOldHokie's post in the thread 20 hours on new Machine, Hydraulic Pump Failure, Advice needed. with Like.
A lot depends on how it failed. My bigger concern would be why... Dan
-
THave you checked this pressure relief valve?
-
TThe bad news is that when the forward pack was operating with low pressure, the clutch pack was slipping and has toasted some of the...
-
TI am a little confused by the question. Did you plumb the backhoe as shown below? Dan
-
TTx Jim replied to the thread Hydraulics are too fast, or Im too slow.Several yrs ago while handling rd bales with a Kubota M4900 with Kubota FEL I added an adjustable hyd flow control valve so boom...
-
