Tx Jim's latest activity
-
TDiesels don't vapor lock. You have junk in the tank/ lines/ filters.
-
TTx Jim replied to the thread M7040 update -hydraulic shuttle won't engage when hot.Congratulations on getting your tractor repaired. Thank you for updating your thread. That may help future viewers with similar hyd...
-
TI've had a relief valve in the position control valve assembly) stick and cause this exact same thing. I did 8 or 10 of them before I...
-
TTx Jim reacted to TheOldHokie's post in the thread M7040 3 point weakens throughout the day with
Like.
No, you did not mention any of that and this is not adding up. You only had 1300 PSI cold yet you say the lift works fine when the oil... -
TTx Jim reacted to TheOldHokie's post in the thread M7040 3 point weakens throughout the day with Like.
Ask "everyone" what they expect to learn by testing the new pump. Lets backup a minute. When you tested pressure at the remote did you...
-
TTx Jim replied to the thread B7610 stalled with pto engaged, now will not start.Welcome to this forum I suggest to check battery voltage & load test battery. If battery passes test then clean/tighten all four battery...
-
TTx Jim reacted to TheOldHokie's post in the thread M7040 3 point weakens throughout the day with Like.
There arent many places to use as test points in that plumbing. Kubota wants you to use a "special tool" (adapter block) to connect a...
-
TTx Jim reacted to TheOldHokie's post in the thread M7040 3 point weakens throughout the day with Like.
The PS has its own pump and is a different circuit. I will have to do a little research on the M7040 plumbing to see where to go next. Dan
-
TLets use the actual labels on the valve. There are two ports marked P. They are both pressure in from the tractor. You can use either...
-
TThere are no NPT ports on that valve. Everything is SAE oring boss - DO NOT USE SEALANT. Dan
-
TTo stop the circulation to the heater core, create an H fitting and install a shut-off valve on each hose above the H, as well as a...
-
TNo expert here on this subject but recently aquired a b3030 cab and been looking through wsm. Have you tested the pressure yet? There is...
-
TK.I.S.S. First clean the radiator and condenser screens and back wash the radiator and condenser with a hose. Next put a set of air...
-
TIt is actually at the local Kubota dealer. They did the pressure tests (I do not have a gauge or fittings) and made a case with Kubota...
-
TI can't help wondering what the pressure readings might have been that indicated they needed to make a case with Kubota. The tractor is...