Tx Jim's latest activity
-
TTx Jim replied to the thread Mx5400 Gear Drive won’t shirt.Start tractor & after engine reaches operating temperature block traction clutch pedal down. Let engine operate a few minutes in this...
-
TYour quest for understanding is commendable. This is an open center system with fixed displacement pump. When the engine is running...
-
TSo when the actuator opens, it closes the open circuit back to the tank and creates direct pressure from the pump to the cylinder, until...
-
TI will also.point out that when you put a pressure gauge on the end of the imlet supply hose for the loader you are totally blocking...
-
TIts possible.The main relief valve is in the outlet block with the selector valve. The pressure test of the loader supply hose will...
-
TTx Jim replied to the thread L2900 Won’t turn over..Appearance of a battery cable connection can look good similar to a good appearing woman but be bad just the same!!
-
TTx Jim replied to the thread Mx5400 Gear Drive won’t shirt.Has tractor been setting idle for any length of time? It's possible clutch plate is stuck to engine flywheel.
-
TThat is a purely a mechanical shuttle, no electric involvement. If you can shift it when it's not running then you have a clutch or...
-
T12V @ 10mA will deflect a voltmeter but wont crank the starter. To fire up the starter you need several hundred amps. These types of...
-
TTx Jim replied to the thread L2900 Won’t turn over..I suggest to check/clean/tighten all 4 battery cable connections paying special attention to ground cable to frame connection. I also...
-
TTx Jim replied to the thread Kubota M7040 Cab w/ac.Welcome to this forum I suggest to acquire/read a M7040 tech manual. I think radiator on my '11 M7040 can be R&R without disturbing AC...
-
TTry your local tractor dealership. Radiators are pretty basic - If you feel you need detailed step-by-step instructions to change a...
-
TTx Jim reacted to TheOldHokie's post in the thread M4900 Hydraulic Problems. Power steering, PTO are OK. Everything else weak with
Like.
The pump has self destructed from oil starvation or over pressure. A seal kit is not going to fix it. If the new pump will fit put it...