Recent content by tom135ca

Thanks Gallows for your insight, I looked at the 1500, I think based on your notes I'll go with that size. Thanks again, really appreciate it.

Good Day, Looking for a little advice, I own a B2650 HSC and would like to purchase an HLA snow pusher. I'm not sure of the model that may be suitable. I'm looking specifically at the HLA 1800 and the HLA 2500. The snow pusher would primarillary for back dragging, then finishing off the area...

Wondering if anyone came up with a part number for the kit need to fix this problem.

Thanks for the reply Onsiteman. Is the selector button mounted on the control. When I'm snowblowing, i tend to keep my hand on the lever, i would be good with the kit if the button is able to be mounted on the lever.

Hi All; I currently have a 3ph snowblower on my B2650HSDC. the blower came with a Hydraulic chute rotation and a manual deflector. Last year I modded the deflector with a linear actuator, work well but gave up this year. I would like to convert the chute deflector to hydraulic, Kubota BL2666a...

Hi everyone, I picked up a flashing amber light that I would like to install on the cabs roof. Has anyone done this. The problem I see is the roof is made out of foam, not sure if this is doable. Any help is much appreciated. Cheers

Thanks everyone for the info, great catch on the switch, I'm going to look at the suggestions, looks like I'm on hold for a little bit. Yesterday I took a 12V battery and tested the wiring and actuator, the blue and green wires are the ones needed. So I will run the wires up to where the...

Thanks for the insight, I will have to google the wiring, This is the actuator that I bought. https://www.ebay.com/itm/4-Heavy-Duty-Stroke-225-Pound-Max-Lift-12V-DC-4-inch-Linear-Actuator-FAST-SHIP/192045768646?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649 This is the switch I'm...

Thanks CharlieFoxtrot, The washers are a great idea, I think I will pick up the same ones that are on the manual slide adjustment. the inside diameter is the same. Lol, I think I will have to stick with a DPDT switch, I can barely keep up with that. I think I will try to see which wires go up...

So wiring is something i need help with. My plan is to extend the actuaror wire harness to where the hyd lines for the snow blower plug in, I'll use a weather pak connector, other side of harness will go to a momentary switch. Here is what I got so far; Motor side End of harness If someone...

Hi everyone, This is my first fabrication, all comments encouraged as I do not know what I'm doing :) The first thing I wanted to tackle was install an electric actuator to operate while in the cab. Took off the plastic knobs and replaced with 5/16 x 18 locking nuts , they are tightened to...