Recent content by Tiberius

Love the Marvel reference (unobtanium)! At least I think that was from Marvel! You and @JimDeL are all over this! I didn't even have to turn the key to the start position to see the effect of the load, especially since turning the key to On only dimly lit the indicator in the first place. I...

Thanks Jay. I just took a voltmeter and checked from the positive lead at the starter to the negative terminal of the battery and got a solid 12.6 volts. Did the same thing from the positive lead at the starter but checked it to the chassis ground and received the same voltage reading. I left...

Hello! My G5200H is being stubborn. I just bought it used and replaced the battery and ignition switch. It started up after sitting in the seller's garage for over two years, it does run great! With no other changes/replacements to the electrical system and not much use while cleaning it up...

Agree... I counted about 36 loops in the coil and considering a spring length of 9", an inch off each end for the loops/hooks, that's a wire thickness of about .2", five per inch. I should be able to find something along that line.

The only picture I've seen of one is in the IPB manual and that's a drawing and a b&w photo (attached), no specifications for it other than "Spring" and the part number. The dimensions you provided should get me in the ballpark. If I go too thick on the wire size, I still don't see it lifting...

That's a great start! Thank you! I should be able to find something that will work in that space, just wanted to avoid getting something too long in there and it wouldn't serve the purpose.

Good morning. I have a G5200H with the 46" two-stage snowblower and I do not have the assist lift springs, pn# 70060-01359. I really don't want to pay $50 each for new ones so I'm wondering if anyone knows the specifications (length, tension, etc.) on these springs that would assist me in...