TheOldHokie's latest activity
-
TheOldHokie replied to the thread Lift arms on 2350DT stuttering with auger attachment.The "misadjusted nut" is on the feedback linkage. That was introduced in post #10 abd discussed at great length. Had you mentioned the... -
TheOldHokie replied to the thread MX5400 adding draft control and rear remotes.The cast iron housings look nice so yeah - curb appeal helps sell tractors. The couplers inside are generic two way sleeve couplers that...
-
-
TheOldHokie replied to the thread B2650 3pt PTO driven leaf mulcher / vacuum.In my case I dont even have a deck. I have a 25' long x 8" dianeter hose with a rigid 4' long pipe on the end that I use to vacuum...
-
TheOldHokie replied to the thread B7800 front axle ball bearing question.Jaw boning isn't going to resolve your issue. Pull and inspect the shaft. A typical press fit on a C3 bearing would be a scant ,001...
-
TheOldHokie replied to the thread MX5400 adding draft control and rear remotes.What can I say. Mine don't leak a drop. Msybe I should buy a lottery ticket The cast iron housings are nothing more than a proprietary...
-
TheOldHokie reacted to Hugo Habicht's post in the thread How to test a B7200D Dynamo Winding with
Like.
Hello John, measuring a resistance that low with a multimeter is challenging. Wire and contact resistance are significant. Normally a... -
TheOldHokie replied to the thread MX5400 adding draft control and rear remotes.The new style is cheaper and easier to make. The old style cast iron housing was eye candy and assuming the new styke couplers are...
-
-
TheOldHokie replied to the thread M7040 3 point weakens throughout the day.I dont know what you fixed but the PCV/CSV are on the downstream side of the remotes. A bad CSV can bleed off lift cylinder pressure but...
-
TheOldHokie replied to the thread MX5400 adding draft control and rear remotes.I cant help with draft control but here are your remote kits. New style is a change in the mounting system. You want new style...
-
TheOldHokie replied to the thread 1630 loader hydraulic controller replacement.Just ti be crystal clear. Remove the plug in the N port and install the sleeve. That port then goes back to the LEFT port on the...
-
TheOldHokie replied to the thread 1630 loader hydraulic controller replacement.The tank (T) port goes to the transmission. You need to install the power beyond sleeve in the N port. Dan
-
TheOldHokie replied to the thread 1630 loader hydraulic controller replacement.Whats the question? Dan
-
TheOldHokie replied to the thread M7040 3 point weakens throughout the day.Yes, in this case you can just replace the factory U-tube with the test equipment. I will get this made up ASAP. Are you OK with male...
-
TheOldHokie replied to the thread M7040 3 point weakens throughout the day.Here is a basic test rig. Right end goes to pump delivery and left end goes to sump. You hook it in, open the flow control valve to...
-
-
TheOldHokie replied to the thread M7040 3 point weakens throughout the day.Any hoses or fittings to go with that?
