Swede1962's latest activity
-
Swede1962 replied to the thread 1980 B6100 4x4 - Looking for loader..Did I remember to send you pictures of the loader that 1980 sent to me? If I did, sorry for the duplicates. -
-
Swede1962 replied to the thread B670 Backhoe for B7100.Not in this case. It would have required a new throttle cable and some re-engineering. Not needed in my opinion. Been tilling 3 seasons...
-
Swede1962 replied to the thread B670 Backhoe for B7100.I purchased one of the HF engines for a defunct Snapper rear-tine tiller. Bolted right up and performs very well. The only take away is...
-
I love finding big grease blobs on my concrete floor the next morning!
-
I'm so good at it I find the blobs WAY before that!! ;)
-
My in-laws recently bought some land and I found this kubota in the woods. It was completly coverver in vines but I managed to get it...
-
Swede1962 replied to the thread Is there interest in a DIY Loader Kit for B6100/B7100?.Any chance you have completed the upgrades you spoke about concerning a quick change setup on your B219? I'd love to see as much of it...
-
Swede1962 replied to the thread New decals and placards.Will photo's with a tape measure strategically placed measuring between certain points be helpful? I'll take a few photo's this way and...
-
Oh, and another thing: the colour scheme used by print shops is normally CMYK (cyan, magenta, yellow, black, colours used for printing)...
-
Swede1962 replied to the thread New decals and placards.It seems like this is something you could be doing for Kubota owners all over the world with vintage machines like mine. And believe me...
-
Swede1962 replied to the thread New decals and placards.So scan it in what format, PDF? And then print that somehow and apply it to the existing dash panel?
-
Laser engraving or making a Lexan overlay ist no problem, plenty of companies offering that. Or you can get self adhesive single use...
-
Swede1962 replied to the thread New decals and placards.I have a couple of speciality engravers in the area and I know they both use both old school engraving techniques and lasers. You just...
-
It may be too expensive but there are nameplate companies that can print onto aluminum and SSt sheets. Heck in today’s world they can...
-
Swede1962 replied to the thread New decals and placards.I have the decal for the glow plugs and the decompression knob. I’ll check with some graphic places and see if it can be done.
