Shawn T. W's latest activity
-
Shawn T. W reacted to g_man's post in the thread What did you do to or on your Kubota today? with
Like.
I had a dead fir on the side of the road and adjacent to the power line. These are notorious for becoming blowdowns and in this case a... -
Shawn T. W reacted to SAR Tracker's post in the thread What did you do to or on your Kubota today? with Like.
Loaded up the LX2610 on the trailer to help with a re-roof project tomorrow (forks to lift the OSB sheets and rafters up rather than...
-
Shawn T. W reacted to chim's post in the thread What did you do to or on your Kubota today? with Like.
Well, it’s partly a Kubota. The engine is a 1.3L V1305-EBG. Time to do some needed generator maintenance. First is the diesel. It's a...
-
How about: Read and Read - I read that before. I don't read much. Live and Live - Live and in person. I live here now.
-
-
Shawn T. W reacted to Bee-Positive's post in the thread Wheel Weights on The Cheap For BX Series ...... with Like.
I used an old pair from a Craftsman lawn tractor my BX replaced, 50# each. Just had to buy longer threaded rod to reach. Sears still...
-
Shawn T. W replied to the thread L3400 1,200 Hrs - Transmission issues.I'd just drain what's in there, and fill it up with fresh SUDT2 ... Not sure if there is a suction screen in addition to the filter(s)...
-
Shawn T. W reacted to PoTreeBoy's post in the thread L3400 1,200 Hrs - Transmission issues with Like.
I'd figure out just how low on fluid it is and fill it up. Low fluid could cause your problem.
-
Two cylinders doesn't necessarily mean twin lids. Mine has a single lid with a cylinder at each end. It operates same as boom or dump...
-
Shawn T. W reacted to S-G-R's post in the thread What did you do to or on your Kubota today? with Like.
Watering trees. The dealer dropped off my GS1572 a couple of days ago. The rear blades didn't show up yet but I may give it a workout...
-
Shawn T. W reacted to nerwin's post in the thread What did you do to or on your Kubota today? with Like.
There's always something! Decided to get this eye sore out. It was a little tricky but I got it out safely. Tried pulling it down...
-
Yes the cylinder's began closing, one comes (usually) against something, the the second goes until it's tight on something. If you...
-
You could use the rear remotes to power the grapple, just require hose to get there. One set of hoses powers both cylinders if you...
-
Shawn T. W replied to the thread Grapple University.Thank you. Two more questions ;) 1. So do they close at the same time, or does one cylinder go until it can't close anymore, then the...
-
Shawn T. W replied to the thread Grapple University.Two questions. 1. Could you use a standard "rear remote" to power a grapple? 2. For the twin piston design, do you need two "sets" of...