Recent content by scooter_trash

Waiting on all parts to arrive. I’ve gotten all the assembly components cleaned, particularly gasket and oring surfaces. Do these flat joining surfaces deserve any grease ? The orings make the seal, and actually after 40 some years I guess most of these un coated surfaces looked pretty good...

I was a little shy about wacking that shaft, but after studying the parts diagram I talked myself into it. Once I saw the shaft circlip groove move below the top of the bevel gear, I knew it was going right. Thanks for your assistance! It appears there are two oil seals on that shaft, guess I...

Thank you! I guess I should invest in a service manual. Folks on eBay are pretty of proud of them... I found the exploded parts diagrams on the Kubota site, thanks for the offer. I had removed the assembly from the axle and put on my bench last night. So bear with me as I regurgitate what *I...

Hello all, new member here. Owned this B9200HST DP for a couple years now. Runs strong. It has a bush hog brand 1945 FEL. I use for the loader of course, and several 3-point attachments such as a tiller, box grader, wood chipper, 4 ft rotary cutter. Last year I decided the hour meter may be...