Russell King's latest activity
-
RRussell King replied to the thread b8200 3pt pin size.@North Idaho Wolfman and I are both wondering where the vertical rod between the upper and lower arm has gone to? In this picture I...
-
-
RRussell King replied to the thread Putting the cart before the horse…..Three Phase power question???????.You might want to put down some like Ram board down to help protect floors and walls from grease or scratches...
-
RRussell King replied to the thread Remote Rear Hydraulics.The PB sleeve is specifically made for the valve model. It provides protection to the valve from damage due to high pressure in the...
-
RRussell King replied to the thread BH75 Backhoe hyd lock.You can try this: Put that stabilizer on the ground. Mark the hoses and cylinder so you can get them back where they went. Remove the...
-
RRussell King replied to the thread M6800 water in hydraulic oil again. Won't move at 26F. Additives?.You might want to cover any entrance into the transmission while it is sitting. Like a tarp over the operators area, a bucket over the...
-
RRussell King replied to the thread b8200 3pt pin size.That is probably going to be a dealer only part… I don’t remember why I think that but that’s what I recall. Did you look at the...
-
RRussell King replied to the thread Putting the cart before the horse…..Three Phase power question???????.Perhaps “How many pieces can be removed from a Bridgeport mill” or”How many pieces does a Bridgeport mill become when rolled down a...
-
RRussell King replied to the thread Flail mowers on a BX.Why do you think they need to be 90 degrees bend? Look at the hammer blades and they seem to be what you want. They would all be at...
-
RRussell King replied to the thread PTO hydraulic pump.I don’t see where anyone said it was complicated. I just gave him information on how to select the pump he was looking for. But thank...
-
RRussell King replied to the thread PTO hydraulic pump.Another suggestion is to ask about it at a local hydraulic design and repair shop that might know a lot about what is needed- assuming...
-
RRussell King replied to the thread PTO hydraulic pump.If you have an existing pump that you need to replace there should be a nameplate on the pump somewhere telling you the flow and...
-
RRussell King replied to the thread Need info on the L200.The L200/L210 we’re not grey market. They were similar to each other and there is a work shop manual (WSM) here but I did not see an...
-
RRussell King reacted to bsamot69's post in the thread L4400 3 point lift bounces with mow deck with
Like.
I downloaded the wsm from a link shared by y'all on this forum . WOOHOO, followed the linkage adjustment and all is good. Thank you all!! -
RThanks for all the helpful advise. I started with the quick connects under the tractor. Then appeared to be connected correctly but I...
-
R@Russell King Correct, it depends on the thickness of the steel. Here's a current listing, which is pretty much on-par with the...
