Russell King's latest activity
-
RRussell King replied to the thread Grinding noise.I imagine that the goats would eat just about anything they can get to!
-
RRussell King replied to the thread Need help removing this part from bushhog.Not knowing the exact construction of your bush hog, I think you can now remove the gear box if that is in your plan. If that is not in...
-
RRussell King replied to the thread Need help removing this part from bushhog.What do you think is left that screws off? I just see the shaft and hub remnants in that picture. The stump jumper is usually very...
-
RRussell King replied to the thread ZD326 Frozen Scalp Wheel Shaft Troubles.I think you may be mistaken, but it certainly could be me that is incorrect on what he is discussing! But somewhere in post #1 he...
-
RRussell King reacted to Mr Haney's post in the thread ZD326 Frozen Scalp Wheel Shaft Troubles with
Love.
I have to pat myself on the back for guessing your profession. You repeatedly insist I bashed engineers as a whole ("all encompassing... -
RRussell King replied to the thread B7500 start problem.You need to let the starter cool down! Crank 30 seconds then wait 120 seconds. After a few cranks (5-8?) walk away and come back in 15...
-
RRussell King replied to the thread ZD326 Frozen Scalp Wheel Shaft Troubles.Then just state the problem you see and stop bashing the engineers. Yes I was an engineer so your comments are personally offensive to...
-
RRussell King replied to the thread resurrecting l245dt, fluids question.Go to this site and move down to where you see a tractor and click on the tractor https://kubotabooks.com/homepage/ You should see an...
-
-
RRussell King replied to the thread B7500 start problem.I’m voting for you need to bleed it again since that is cheap!
-
RRussell King replied to the thread Dynamo and belt install bx2230.The belt will probably be the hardest to get off and on. You will have to feed it over the fan (I think) to get it on. You can usually...
-
RRussell King replied to the thread Grinding noise.I agree with @Henro that your trouble is in the mower or mower drive system. There are three (or more?) spindles that hold the blades...
-
RRussell King replied to the thread ZD326 Frozen Scalp Wheel Shaft Troubles.The Challenger did NOT fail from an engineering error, it was launched outside the temperature range of the design parameters. It seems...
-
RRussell King reacted to Hugo Habicht's post in the thread ZD326 Frozen Scalp Wheel Shaft Troubles with Like.
Has been mentioned already: what you encountered is absurdly incompetent operators. I would suggest to consult the operator manual...
-
RThe one you suggested.
-
RRussell King replied to the thread Air in hydraulic system.@TheOldHokie did not state it explicitly but the hose end in the bucket must be open for flow. If there is a disconnect on the hose end...
