Russell King's latest activity
-
RThis looks like the answer. I started it tonight and got off. Within a minute or two it had started running rough. Instead of...
-
RRussell King replied to the thread Where do I start?.I assume that is seepage from a plugged hole. I assume that plugged hole is NPT thread that isn’t the best sealing thread without being...
-
RThat was it. Crazy that it worked all morning like that with out and issue. Thanks for the help.
-
RRussell King replied to the thread L3350 PTO Guard.Try these people for new This salvage yard may have one used
-
-
RThe black line is a return to the tank. The red is from the engine or the pump. The green goes to the 3 point. The yellow is a bolt...
-
RHere's a pic of the label.
-
RRussell King reacted to TheOldHokie's post in the thread Bradco 715 front blade attachment with
Like.
I think I smell a rat!!! Your blade has one double acting cylinder for up/down. That is opetated by ONE double acting spool on the... -
RRussell King replied to the thread Bradco 715 front blade attachment.@TheOldHokie and @Joekelsch I noticed that there was a better view of the tractor block and marked it (hopefully the same. I am not...
-
-
RRussell King replied to the thread BX2230 intermittent starting issue.Try to “jump” the starter positive cable to the solenoid spade terminal and see if the starter will reliably engage and crank the...
-
RRussell King replied to the thread MX5400 HST third link issue..Is there a three point speed control knob on that tractor? If so, it may be set to really slow down or locked so it can’t move down. I...
-
RRussell King replied to the thread Trailer.Here is a thread on using a tipper trailer on a different but similar tractor...
-
RRussell King replied to the thread Bradco 715 front blade attachment.Can you see any markings that are cast into the valve (similar to the “out”)? I would assume that there is an ”in” and possibly a “T”...
-
RRussell King replied to the thread Kubota B3030 Air Conditioner.Yes that is them. Since they are a long run you should be able to find a point to see if they are both warm. You can just remove those...
-
RRussell King replied to the thread L5240 HST dying, fuel or HST?.After it starts and gets to speed, can you use it normally or does it stall out in short order. I think you will get better advice if...
-
RI did not miss the comment but I think you missed this one The LA482 manual is clesr 45mm (1.77] x 450mm (17.7). That would be a 1-3/4...
