Russell King's latest activity
-
RSale pending...
-
RRussell King reacted to Hugo Habicht's post in the thread OEM Ignition Switch for ZD326 Worth the Extra $70+? with
Like.
Yes this is correct, the controller (as far as I can see in the schematics) is for safety reasons mainly. The engine could run without... -
RRussell King replied to the thread L3650 Loader Trouble When Lowering.Glad you’re complete with the adjustment. Did it resolve the issue? Or are you just leaving the 3PH in the lower position? And then...
-
RRussell King replied to the thread L3650 Loader Trouble When Lowering.You may read this thread and get the information you need or show that Kubota calls it control linkage. See post 7, 11 and 13 for...
-
RRussell King replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.@Mr Haney The PURPLE and RED in the marked schematic are close in color so be careful when looking at the screen to notice the...
-
RRussell King reacted to Hugo Habicht's post in the thread OEM Ignition Switch for ZD326 Worth the Extra $70+? with Like.
Here the wiring: red - 12V path for starter current to starter switch yellow - starter solenoid current path from start switch via...
-
RRussell King reacted to Hugo Habicht's post in the thread OEM Ignition Switch for ZD326 Worth the Extra $70+? with Like.
The controller is very useful, may save your butt if things go wrong. And it's not the controllers fault if it gets fed wrong signals...
-
RRussell King replied to the thread L3650 Loader Trouble When Lowering.Can you really raise kangaROOs in Vermont? Sorry to sidetrack the conversation and I’ll leave it to @TheOldHokie to explain why the 3PH...
-
RInteresting!! Lowering my 3pt hitch completely to the bottom allowed downward pressure to work again! I didn't know to check for that...
-
RRussell King replied to the thread B7100HST engine swap with b6200E.I’m impressed by the radiator and the bumper!
-
RRussell King replied to the thread What tools/wrenches to do basic maintenance/servicing on L3902?.You will need to get sockets and wrenches above the normal car sets that usually stop around 20 mm or so. Get up around 20 up to 28 mm...
-
RRussell King replied to the thread 2019 KX057 looses power.Are you sure it is NOT overheating? Sounds like classic overheating problems.
-
RRussell King replied to the thread Brake problems.I looked at how his brakes are arranged and they are double disks on both sides so four disks total. The two disks are able to slide...
-
RRussell King replied to the thread Brake problems.My brakes will stop my tractor in either direction. Mine are a disk brake of some kind and squeal in reverse but not as much in...
-
RRussell King replied to the thread D902 3-Cyl PFR-KD Zexel Injection Pump Troubleshooting.I am sorry that you feel insulated by any of the posts in reply to your question. Would you please be so kind as to state what...