Russell King's latest activity
-
RRussell King replied to the thread Hooking up third function, rear remotes, and a backhoe line..@TheOldHokie Seems like that question is making the rounds this month! I just asked the same question about a week or two ago.
-
RRussell King replied to the thread Hydraulic pump strain.The feedback rod is mal-adjusted. Here is a link to a thread that has instructions for adjusting it (without an implement on the three...
-
RYes, I forgot to do that when I replied.
-
RRussell King replied to the thread What’s with all the SPAM?.This is way off subject but… I agree that raw pork is bad for humans and canines. I agree that pork in the form of bacon and ham is not...
-
RRussell King replied to the thread Fuel in oil.Did you see the pictures inside the quote section in post 4. I imagine you can move them into the reply section instead of the quote...
-
RRussell King replied to the thread 2004 Grand L5030 will not start.Ok it sounds like you have some electrical issues to deal with. Since you can hot wire it, the starter and solenoid are good. Explain...
-
RRussell King replied to the thread MX 5100 float position on rear remotes.So do you need it on both hoses or is one enough? I believe that disconnecting one side of the cylinder locks it in place but don’t...
-
RRussell King replied to the thread MX 5100 float position on rear remotes.You can mount the check valve remotely to the cylinder and use it when you need or want to. You would need a couple of extra hoses.
-
RYeah. Can’t move it at all. And I did note in the manual that it shows no clip. Assuming the safety chain is the fail safe in that...
-
RRussell King replied to the thread Slip clutch.@Bsromine I edited the post above this one (#10)
-
RRussell King replied to the thread Slip clutch.Sorry to continue but that is pretty much exactly what I tried to describe getting off my tiller by driving the yoke onto the input...
-
RRussell King replied to the thread Slip clutch.I looked at parts lists of your mower and am confused to say the least. The gearbox shows a groove for the cir-clip! The driveline for...
-
-
RRussell King replied to the thread Slip clutch.At about the 4:00 minute mark he makes a comment about “nothing else to lock” that part in place. I disagree with that and think there...
-
RRussell King replied to the thread MX 5100 float position on rear remotes.Deleted post after seeing other posts
-
RRussell King replied to the thread Slip clutch.Pictures of the problem may help get suggestions. On my tiller when the drive shaft was rusted to the tiller’s input shaft (which is...
