Russell King's latest activity
-
RRussell King replied to the thread Can’t connect loader hydraulic latch BX.You do need to relieve the pressure on all the lines that are connected from the FEL to that mounting block. All on the FEL SIDE. The...
-
RRussell King replied to the thread Help needed on a decision about rear hydraulics.You can get a kit from https://www.fitritehydraulics.com/ The owner is @MtnViewRanch (member here). Lead time for cylinders may still...
-
RRussell King replied to the thread New decals and placards.Some of those appear to be available. Look at #66706-47240 DECAL for the glow plugs label. Look at. #66706-47270 DECAL. For the...
-
-
RRussell King replied to the thread Reviving a G1900.@lmichael just remember that 1 inch is 25.4 mm (or just use 25 if you don’t want an accurate measurement) X inches * (25.4 mm/1 inch)...
-
RRussell King replied to the thread Frame Captive Nuts.You should be able to find something. Search for cage nuts or snap in nuts and find things similar to this...
-
RRussell King replied to the thread Good running to bad in an instant.Sounds like you still have a fuel restriction. Runs OK at first (has plenty of fuel) then runs rough(lack of fuel). Let it sit and...
-
RRussell King replied to the thread RCK60 belly mower guide wheel.So the bracket on the mower deck got ripped off also? You will probably have to get that fabricated by a welder. If the deck still has...
-
RRussell King replied to the thread RCK60 belly mower guide wheel.You can get it from a Kubota dealer. How much of it is missing?
-
RMuchly appreciate all the advice guys,I usually overthink everything so i was concerned about breaking something else but everything is...
-
RRussell King replied to the thread T1760 clicks but won't turn.The battery may be bad. You can have it load tested at an auto parts store to see how much the voltage on the battery drops under a load.
-
RThnx Russell, I put a pretty good remote jump starter on it, and it started in a snap. I felt it was turning over good enough, but...
-
RRussell King reacted to Hugo Habicht's post in the thread Looking for owners of G1700, G1800, G1900 or G2000, decals with
Like.
I asked somebody living in France for over 30 years. So .... drumroll .... the solution is: " non conforme au code de la route" -
RRussell King reacted to TheOldHokie's post in the thread Backhoe hydraulic connection advice with Sad.
You are welcome - it was a good questiom. The Doc said no milk shake until day 7. Today is day 6 😂 Dan
-
RRussell King replied to the thread Using the drawbar to pull a trailer.Read about the dangers of two wheeled trailers being hooked to the three point hitch (which normally has no resistance to upward...
-
RRussell King replied to the thread P0101 (Intake Air Volume: Low) Warning after replacing dirty air filters.One question for you to be 1000% sure of: Are there any plastic wrappers on the new filters that are restricting the air flow?
