Russell King's latest activity
-
RRussell King replied to the thread Engine oil.Use DIESEL RATED engine oil in whatever viscosity you want to. You probably need to use the thicker viscosity to account for the wear...
-
RRussell King replied to the thread Water in Trans Oil.Condensation, leaking seals on covers, gear shifters…
-
RRussell King replied to the thread 1980 Kubota B6100D 4x4 - Restortation with UpGrades.Not sure why but the left front tire is mounted backwards to the other three - so don’t copy that unless you have a reason to do so...
-
RRussell King replied to the thread Is there interest in a DIY Loader Kit for B6100/B7100?.That person (Sterno) has not been on this site since 2021 so I doubt you will get anywhere with this.
-
RRussell King replied to the thread D902 pistons for bored block.Here is another option if the one above gives you any trouble https://apps.kubotausa.com/illustrated-parts/
-
RRussell King replied to the thread Adding an auxiliary hydraulic pump to grey market b6000dt.Look at what is called a jack shaft arrangement. Mount the belt pulley on a shaft, have that shaft mounted onto two pillow block...
-
RRussell King replied to the thread Adding an auxiliary hydraulic pump to grey market b6000dt.You should read through this thread about a similar situation. I doubt you will be able to find the OEM parts but can adapt these ideas...
-
RRussell King replied to the thread Fuel transfer tank.You could use some high strength (agricultural 20-30%) vinegar or one of these products https://www.kbs-coatings.com/prep rinse out...
-
RRussell King replied to the thread Belly mount GF1800E went bang, then smoke.Not really from just working hard, but from wear and tear over the years, low oil, loose bearings, dirty radiator AND working hard...
-
RRussell King replied to the thread Belly mount GF1800E went bang, then smoke.Bang like some explosion or Bang like something metal coming through metal? I would assume that you have probably thrown a rod through...
-
RRussell King replied to the thread Hard starting LX2610.There is (probably) a solenoid that shuts your engine down (or allows it to run) when the key is turned off (or running position)...
-
RRussell King replied to the thread Leveling a Land Pride Quick Hitch / Proper Angle for Brush Hog.@DawgHouse I am not 100% sure I completely understand the question so may not be answering it correctly. Yes the right hand link is...
-
RRussell King replied to the thread Diesel transfer tank.I wouldn’t worry too much about it. If you’re getting good fuel hopefully there won’t be much water in it to drain out. It may take a...
-
RRussell King replied to the thread Diesel transfer tank.And that set up looks like a perfect mess making arrangement when you need to drain the water or sediment out of the filter. You may...
-
RRussell King reacted to MissyD's post in the thread Skid Steer died, won't start 2022 svl 97 2 with
Like.
After much debate with the Kubota dealer, it was deemed covered under their warranty. It took a long time and I had to keep going back...