ruger1980's latest activity
-
Rruger1980 replied to the thread Kubota M5700 AC Control Blowing Fuses.The only thing that fuse supplies is the AC and blower relays. A total of maybe a half an amp total to power the coils in those relays...
-
Rruger1980 replied to the thread M5400 won't start, have changed most everything.First thing is to unload the parts cannon and then start testing with a multimeter. See attached
-
Rruger1980 reacted to TheOldHokie's post in the thread P0101 (Intake Air Volume: Low) Warning after replacing dirty air filters with
Like.
I suspect the filter is a red herring and the problem lies elsewhere. Dan -
Rruger1980 replied to the thread Kubota L245F No Throttle Control High RPM at start up.The shaft looks like it is still in place, other wise it would be dropped down into the governor ass'y. If the shaft is actually twisted...
-
Rruger1980 replied to the thread Kubota L245F No Throttle Control High RPM at start up.No electric shut off on that vintage machine. Probably goes to the fuel gauge or one of the wires seen under the fuel tank.
-
Rruger1980 replied to the thread Need to find out how to dismantle scraper blade pivot from hitch unit.Looks like they welded it together rather than bolting or coupling it somehow. I suspect they welded it crooked.
-
Rruger1980 replied to the thread L225 transmission vent?.
-
-
Rruger1980 replied to the thread L225 transmission vent?.That is where the seat bracket attaches. It is a through hole but does not go into the housing iit is entirely external.
-
Rruger1980 replied to the thread Kubota L245F No Throttle Control High RPM at start up.Sorry I just reread your last post and you are saying the nuts that hold control lever to the governor shaft are missing? That is...
-
Rruger1980 replied to the thread Kubota L245F No Throttle Control High RPM at start up.When you had the injection pump out and remove the delivery valves out did you remove or alter the position of the barrels that the...
-
Rruger1980 replied to the thread L225 transmission vent?.The L225 does not have a vent like shown for the 185. The fill cap between the shifters and the rear cover has a small hole drilled...
-
Rruger1980 replied to the thread New owner of L175...smokes terribly bad....If you can find a local fuel injection shop to test them for a reasonable fee I would do that first. I am lucky I have a local guy who...
-
Rruger1980 replied to the thread B1750 injection pump rebuild.The pin that was broken is to equalize fuel delivery between each pumping element. There should be shims in the followers that the...
-
Rruger1980 replied to the thread Fuel in oil.If it is truly fuel in the oil it is more likely the transfer or lift pump. It could also be tractor hydraulic fluid which would most...
-
Rruger1980 replied to the thread New owner of L175...smokes terribly bad....Is this with just a cold engine? They will often smoke quite a bit when cold. Try running it with a load to see if it clears up at all...
