ruger1980's latest activity
-
Rruger1980 replied to the thread Interesting diesel additive comparison.From my research California and parts of Texas are the only states I have found that have a requirement above and beyond the US...
-
Rruger1980 replied to the thread Interesting diesel additive comparison.The minimum cetane rating for diesel in the US is 40. Typical fuel is between 42-45. I have never seen a fuel dispenser in the US that...
-
Rruger1980 replied to the thread Tire ballast choices.So doesn't table salt
-
Rruger1980 replied to the thread what is the temperature sender thread size?.Your measurement does match 3/8 NPT. I would try a known NOT plug or bushing to see how far it will screw inton the housing first. If...
-
Rruger1980 replied to the thread Tire ballast choices.CaCl is non toxic and not considered hazardous to the environment. It is considered an irritant to the eyes and skin
-
Rruger1980 reacted to North Idaho Wolfman's post in the thread Yoke OhNo! - Year Unknown - 1980 something M6800 with
Like.
Hard to know for sure from just one picture alone, but it appears to me the seal has broken in half. FYI: That's not a yoke, or a yoke... -
Rruger1980 replied to the thread KX040-4 Mini Excavator Fuel System Issue.Where you are measuring is the supply side of the feed or lift pump I would not be surprised to see a vacuum there. If the electric pump...
-
Rruger1980 replied to the thread KX040-4 Mini Excavator Fuel System Issue.First off where and with what are you measuring fuel pressure? Yes a negative pressure is a vacuum but vacuum is measured in inches of...
-
Rruger1980 replied to the thread Rolling coal? Lots of soot under load - B2601.Soot is the first and primary pollutant regulated on diesel engines. That is accomplished via the DPF or diesel particulate filter. I...
-
Rusing the voltage drop test method can often isolate the problem in less time than it takes to type out the question-and that reply...
-
Rruger1980 replied to the thread L3301HST hydraulic Pressure.Spec is 2280-2410psi
-
Rruger1980 replied to the thread L4310 HST Pedal safety switch.From what I have read, can't find it right now, The early units had a HST switch and then they went to the clutch switch. I see a change...
-
-
Rruger1980 replied to the thread B2366 SSQA Adaptor - Universal?.Tim, the SSQA adapter "should" fit any SSQA attachment made. There are variations in tolerances so some may fit tight and some loose...
-
Rruger1980 replied to the thread L4310 HST Pedal safety switch.I have a L4310. It has a clutch switch. It was never equipped with a switch on the HST pedal. I have to have the clutch depressed to...
-
Rruger1980 replied to the thread L4310 HST Pedal safety switch.I have heard mention of a HST safety switch but never have seen one. All the HST's I have seen have only the clutch and PTO switches.
