pigdoc's latest activity
-
pigdoc replied to the thread Should hydraulic rear lift arms go down after 1 sitting over night ?.Shoot, on my old L2500, I have left a heavy 7-foot LandPride blade hang on the 3-point (off the ground) for months at a time, and it... -
pigdoc replied to the thread l2250 won't move (clutch is fine).Ya, when I read the message subject, my first thought was the Hi-Lo lever. Dang, too bad you went through all that unnecessary work. My...
-
pigdoc replied to the thread Reviving An Old Acquaintance Buried In The Pole Barn.In good running condition, that Panzer could bring $2000 (or more) at auction. I forget what engine they had in them... - Paul
-
pigdoc replied to the thread Reviving An Old Acquaintance Buried In The Pole Barn.The gear box on the digger is actually the salvaged center section of a Chrysler 8-3/4" rear axle. Probably from the 1950s. Probably has...
-
-
pigdoc replied to the thread Starter Relay.Makes perfect sense geohorn. P = E * I You know, on cheap battery chargers, there's a meter that shows % charged. If a 12V battery...
-
pigdoc replied to the thread Deck Belt Brands.I bought an aftermarket belt for my RC-54 deck off eBay. This one: https://www.ebay.com/itm/326772864134 After 3 seasons of use, I'm...
-
G2160 wiring = 🍩 G1900 wiring = 🍄 Pretty hard to compare a doughnut to a mushroom!
-
pigdoc replied to the thread Starter Relay.My L2500 has an ancient old battery in it. Won't hold a charge, so I can't tell (without doing some diagnostics) if the charging system...
-
pigdoc replied to the thread L2350 Getting air in fuel system.I have had to fiddle with fuel lines on my L2500 a couple of times in the last couple of years. When that fuel line gets old (we're in...
-
-
I have seen an extra relais in front of the starter a few times, mine had that too, but I think it is only covering up a problem with...
-
What's the Dorman number, so I can lookup the specs.... or can you measure the resistance ? FWIW the sender for my BX23S is +-100 ohms...
-
pigdoc replied to the thread G1800 will not turn over.On my current G1800S, I have had a long-standing 'problem' on starting. There is also a start-safety switch on the brake pedal. If you...
-
pigdoc replied to the thread G1700 G1800 G1900 frame breaking?.I have been mowing with a G1800 or a G1800S for about a dozen years (two different machines). Two similar yards, two different machines...
-
pigdoc replied to the thread L235 front driveshaft.Any idea WHY the front driveshaft coupler stripped out? Asking because I had the same issue in a tractor I purchased. PO (previous...
-
-
pigdoc replied to the thread fel control replacement.Ya, I had that problem with my FEL controller. Replacing parts 010 and 020 (on the diagram above) solved all my problems. Still got the...
