Recent content by Oleracer

6 harleys 2 classic cars few trucks. Just no room😂. I actually would like to keep it with the plow. Hey maybe nobody will want it. But its going to live outside.probably not great as its been indoors last 15 years

Now have 2. B2150s But one with cab probably sell it after i pull cab. Sell tractor maybe pull brush hog or sell separately. Its not as nice as my 300hour garage queen but it has 1200 hours. Snow plow nice with down pressure probably nice for side walks

I am sure its been rattling around for a while. Blizzard probably did it in….but run it pretty easy.

Nope its OEM never apart 300 hours tractor What like 30-35 years old. I have seen input shafts worn on Peterbilts 1 million + miles. Thing is this clutch looked brandnew. Yep race cars we use solid no spring discs. But the tractor never sees any clutch pedal use at all under power. Guessing...

Nope always disengaged… might roll forward or back using the hoe. Run enough dump trucks tow trucks RGNs to watch that closely… good thought! But if it was how do you use a brush hog ? I don’t but thought it would be same

Well it wasn’t the coupler. Clutch disc pressureplate and flywheel looked new . Ate the splines out of the disc. First for me and done a lot of clutches from Peterbilt to race cars. Ate the shaft also maybe too soft should have burnt clutch first . Machine only has 300 hours i only use...

Thank you. Hopefully thats all it is. 👍

Is the coupler still available… have bad feeling i broke it on this bad snow storm. 250 hour b2150hst. Noise let clutch out no drive. Fun i guess.

All above good ideas. Dont be afraid to weld a big nut on pins so you can work pins back and forth twisting after heating.Done lots of pins PBlaster is in the service truck. Before welding nuts ream the threads out to get more surface area for welds and remove plating. Good luck. BFH also

Paper clip trick first time ole farmer taught me at 14 years old. Amazing how pain level drops . Probably didn’t smash another finger till 20 years old 😆

Oh come on…. You really need a mag drill 😆

If you can weld them on. Have seen bolt on stuff rust and rot under the area its bolted unless its a garage queen never used . Never needed a a center hook on these little tractors with thin buckets. Paint adds 5k more capacity!

Hawk likes sitting on the ole Mercedes watching for squirrels….😆

Even better 😆. Now adays thats a good company to deal with 👍👍👍

Best way and it will be exact… simple easy fix/modification. Shims are for doors on the house