Old Machinist's latest activity
-
Old Machinist replied to the thread What did you do to or on your Kubota today?.Years ago I built a ground powered mower I pulled behind my car to keep me out of the elements and dust. The very first time I used it... -
I would second this. I have used this forum on and off for years for information for my old Cat track loader. Ten years ago I had a...
-
Old Machinist replied to the thread King Kutter finish mower bearings.Here is a kit on Amazon for $31. Doesn't show any wave washers but claims to be exact replacements and has 88 5 star ratings.
-
Old Machinist replied to the thread Forum for Kubota Excavators.Not Kubota specific but Heavy Equipment Forums has a excavator specific group. I frequent the backhoe group and it has lots of helpful...
-
Old Machinist replied to the thread Adding voltage gauge - questions.You should never have anything connected un switched. Since you connected it to the starter positive I suggest you remember to turn the...
-
Old Machinist replied to the thread Brittle Fender.I hate brittle plastic. My JD F725 has broken pieces all over. Doesn't do much good to repair it since it will just break in another...
-
Old Machinist replied to the thread Regen cycles on lx3310.My LX3310 just performed it's 6th regen in 110 hours. EDIT: I just realized my math was off because I shouldn't count the first regen...
-
Old Machinist replied to the thread Box or Grading Scraper?.I use my box blade most of the time. A landscape rake does a good job on gravel if you don't want to move a lot of material and just...
-
Old Machinist replied to the thread What did you do to or on your Kubota today?.Washed mine and cleaned the radiator and condenser also. Did a lazy man's wash on the outside. I used a Ortho chemical sprayer on the...
-
Old Machinist reacted to nerwin's post in the thread What did you do to or on your Kubota today? with
Haha.
Went to the Kubota dealership today to get oil change stuff. Got the oil, 7 quarts, oil filter, air filter and fuel filter for $113... -
Old Machinist reacted to chim's post in the thread What did you do to or on your Kubota today? with Like.
Although it was hot early today it was time to pay some attention to a few things. Cleaned underside and sharpened the blades on the...
-
Old Machinist replied to the thread Leaky Quick Disconnect BX23 LA210-1. O-ring Replacement vs QD Coupling Replacement (with O-ring Part Number).Looked at mine a while back and tried to match the oring up with one from 6 different assortments and didn't find a match. I put the old...
-
Old Machinist replied to the thread How do you clean your greasy loader pivots?.I keep some mineral spirits in a spray bottle and use that with paper towels. It doesn't get done often.
-
Yep, I won't go anywhere near our town today. It is the annual Ausable Canoe marathon. This is actually a big deal, and is about the...
-
Old Machinist replied to the thread sharpening up backhoe.If it has tooth shanks on it try to find some single point tiger teeth to fit.