Recent content by Mike N KY

I gave in a called the dealer to pick up the tractor yesterday... I will post the results as soon as I hear back..... should be 2 to 3 days????

No the steering and FEL work fine even after the 3pt stops working.

It does not leak down, and will hold its position unless you move the lever down then it will go down but will not raise again until the tractor cools off. It will not raise with or without a load when it is hot. It does seem like to oil is constantly running through because the area around...

I does not leak down, but will lower if you move the lever to the down postion, but will not raise. It will not raise when hot with or without a load. It just seems like the oil is running through all the time because the top of the Hyd coupler area is very hot to the touch.. I just don't...

The Hyd cyl I am referring to is the ones that operate the remotes.. How do I find out if there is a Hyd priority valve? MC

I don't have a laser therm... but if you put your hand on top of where the hyd couplers hook up it is very hot after about 30min to 1 hour of operation. I also put my hand on the hyd pump and it feels hot but I am not sure what one should feel like under normal conditions. I believe it is...

I am not sure but I was told by the dealer that it had been completely serviced before it was put up for sale..... However, I did go ahead and change the filters again last week.

I did clean the hyd oil cooler with an air hose and then the water hose and looked good after..... How do I check for a leaking relief valve? or a cooler problem?? THKS for the help...

Help Needed!! I am a new Kubota owner and new to this forum, and here is my problem…. I recently purchased a used M9540, 4WD, ROPS, Sync-Shuttle 8x8 trans, with 270 hrs on the meter. I was cutting hay with an 8ft disc mower and after about an hour in the 3 pt arms would not work, however the...